TRAXXAS 1/10 T-Maxx Alloy Collars & Screws by GPM TMX13100/SC  [TMX13100/SC]

Alloy collars and screws for 1/10 T-Maxx

This is an RC-scale replacement set of alloy collars and mounting screws designed for use with TRAXXAS 1/10 T-Maxx platforms, produced by GPM under part number TMX13100/SC. The components serve as hardware replacements where original plastic or worn metal collars and fasteners need upgrading to maintain alignment and reduce play in drivetrain and linkage joints.

Intended role: these collars clamp on shafts and axles to locate gears, hubs, or linkage ends and the matching screws secure assemblies that see repeated disassembly or high-load impacts during bashing or trail driving. The aluminum construction provides firmer seating than many stock kits while keeping weight low for scale setups.

Installation notes: work on one side at a time while supporting the vehicle on a maintenance stand, remove wheels and any hub carriers as required, slide off the old collar, fit the alloy collar to the shaft and tighten the set screw to seat it against the shaft flat, then reinstall affected parts and confirm free rotation. Use the correct hex driver size for the supplied screws and avoid over‑torque that can strip threads in plastic housings.

Tuning and service tips: replacing worn collars can reduce driveline lash and improve steering consistency by keeping linkages indexed. Inspect mating shafts for wear or flats before fitting new collars, clean contact surfaces, and recheck fastener security after the first run to confirm there is no loosening under load.