TRAXXAS 1/18 Latrax Rally aluminium front/rear lower arm by GPM LTX055  [LTX055]

Aluminium lower arms for 1/18 Latrax Rally

This 1/18-scale aluminium front/rear lower arm is produced for the TRAXXAS 1/18 Latrax Rally platform and supplied under GPM LTX055. The part is intended as a direct-replacement hop-up to the vehicle's stock lower arms, providing a metal alternative to the original plastic pieces while keeping the factory mounting points and geometry.

Technical role: the aluminium lower arm increases structural durability at suspension pivot points and gives a firmer mounting for the suspension components, which can change feedback and tuning requirements for the chassis. Expect a different feel in response compared with plastic arms; adjust shock settings and toe/camber as needed when installing.

Installation notes: remove the original lower arm assemblies and reuse the vehicle's existing hardware where possible, verify fit at both front and rear mounting points, and check clearance with the servo horn and drive components before final tightening. Hand-tighten fasteners first, then torque to a secure fit while observing alignment.