TRAXXAS 1/18 Latrax Rally Aluminium Rear Shock Tower by GPM LTX030  [LTX030]

Aluminium rear shock tower for Latrax 1/18

This aluminium rear shock tower is an aftermarket replacement designed for TRAXXAS 1/18 Latrax Rally models, supplied as 1 pc by GPM LTX030. It replaces the stock rear tower to provide a firmer mounting point for the rear shocks and to reduce flex at the shock mounts, helping to make rear suspension responses more consistent during tuning sessions.

The part is intended for RC-scale use only. Installation follows the same mounting points as the original tower; keep original screws and hardware where practical and verify thread engagement before final tightening. When fitting an aluminium tower, avoid overtightening fasteners to prevent stress transfer to composite mounts, and recheck mounting screws after the first test run.

As a tuning component, this tower changes how the rear suspension transmits load to the chassis, so expect a noticeable effect on handling when switching from plastic to aluminium. Use this part when you need firmer shock alignment, repeatable geometry under load, and a stable platform for shock tune adjustments.