TRAXXAS 1/18 Latrax Rally front knuckle arm by GPM LTX021  [LTX021]

Front knuckle arm for Latrax Rally (1/18)

This aluminium front knuckle arm is an RC-scale steering pivot designed for the TRAXXAS 1/18 Latrax Rally platform. It replaces the stock front knuckle arm to provide a more rigid mounting point for the steering linkage and suspension upright without implying use beyond the model scale.

Installation follows standard Latrax Rally front-end procedures: remove the original knuckle arm, align the aluminium unit with the upright and steering linkage, and secure using the existing fasteners. Tighten hardware to the vehicle manufacturer's recommended torque and verify full free travel of the steering and suspension after fitting.

In tuning, an aluminium knuckle arm reduces component flex compared with plastic stock parts, which can sharpen steering response and make small alignment changes more predictable. Check wheel toe and camber after installation and inspect mounting interfaces periodically for wear.

A straightforward aluminium replacement for the Latrax Rally front knuckle arm that focuses on durability and predictable steering behavior, suitable for hobby use and setup adjustments on the 1/18 Latrax Rally chassis.