TRAXXAS 4WD GT4 TEC 2.0 Aluminum Front/Rear Brake Disk and Caliper by GPM GT006AB  [GT006AB]

Front and rear brake disk and caliper set

This aluminum brake disk and caliper kit is an RC-scale replacement designed for the TRAXXAS 4WD GT4 TEC 2.0 platform and intended for model-level braking assembly in the brake disk area. The parts are metal machined components intended to replace the stock disk and caliper where the same mounting points are used.

The design features an engraved swirl pattern on the outer ring and an increased disk thickness of 8mm compared with the typical 7mm stock ring, producing a slightly wider track when fitted to both front and rear wheels. The change in track width is intended to influence chassis stability during cornering and straight-line control at model speeds.

Fitment and installation require basic RC hand tools and routine checks: remove the wheel and hub assembly, replace the disk and secure the caliper to existing mounts, and verify screw torque on all stainless hardware. This product is strictly for RC model use and not for real vehicle applications.

Use this kit to adjust braking hardware and slightly widen the wheeltrack for a measurable change in chassis behaviour; confirm fitment with your GT4 TEC 2.0 hubs and recheck fastener torque after initial runs.