TRAXXAS 4WD GT4 TEC 2.0 Aluminum Hex Adapters 7mm Thick by GPM GT010/12X7MM  [GT010/12X7MM]

Aluminum hex adapters for GT4 chassis

This GPM aluminum hex adapter set is an RC-scale replacement part designed for TRAXXAS 4WD GT4 TEC 2.0 applications where a precise wheel-to-axle interface is required. The adapters are machined from 6061 T6 aluminum and dimensioned at a 7mm hex thickness to match upgraded wheel setups that need a slightly thicker mounting face compared with the original 6.8mm brake disk thickness.

Intended use is straightforward: these hexes locate on the axle to transfer wheel loads while maintaining concentric alignment for predictable handling and repeatable wheel mounting. The design focuses on a tight fit on the axle to reduce slop that can affect steering response and tire wear in scale racing or track tuning.

Hardware included in the kit is provided for direct replacement or maintenance during setup changes:

• 2x10 steel pin - 4 pcs
• 2x5 stainless steel cap head screw - 4 pcs
• Hex adapters - 12 pcs

Notes for fitment and setup: the adapter thickness is 7mm, check clearance relative to the original 6.8mm brake disk dimension on your GT4 TEC 2.0 hubs to confirm spacing. These adapters serve as a tuning component to adjust wheel offset and improve mechanical engagement between wheel and axle without changing hub geometry.