TRAXXAS E-REVO Aluminium Front Lower Suspension Arm by GPM ER055  [ER055]

Front lower suspension arm for E-REVO

This aluminium front lower suspension arm is an RC-scale replacement part intended for TRAXXAS E-REVO platforms and similar chassis. Designed to restore geometry and provide a stronger mounting point compared with stock plastic arms, the component is supplied as a one pair set for front left and right positions.

The arm serves a tuning role in front suspension setup, affecting roll centre and camber behavior under load. When replacing worn or damaged arms, confirm fitment against the listed compatibility and check that existing hinge pins and hardware match the arm's hole spacing before final assembly.

Installation notes: use existing hinge pins where compatible or replace with the correct size pins, tighten screws to secure the arm without over-torquing to avoid thread damage, and verify free suspension travel after installation. This part is an RC accessory only and not intended for full-size vehicle use.

Use this aluminium front lower arm to replace damaged stock parts or to add a durable option for front-end tuning on TRAXXAS E-REVO based models, and recheck alignment after fitting.