TRAXXAS E-REVO Aluminium Wheel Hex Claw +2mm with Brake Disk by GPM ER0062MM/4  [ER0062MM/4]

Aluminium wheel hex claw for E-REVO

This aluminium wheel hex claw set is designed as an RC-scale replacement for Traxxas E-REVO wheel mounting hardware. The +2mm offset and integrated brake disk feature provide a direct way to stabilize wheel fitment and preserve alignment under load. The parts are intended for model use only and fit E-REVO wheels where a slightly wider hex is required.

Installation is straightforward for experienced hobbyists: remove the stock hex, fit the aluminium claw onto the wheel hub, and secure with the original hex screw pattern. Because the part increases the wheel offset by +2mm, verify wheel clearance against suspension and body mounts before final tightening. Use threadlocker on mating screws if you expect heavy use, and check wheel runout after installation to confirm correct seating.

In tuning and setup, these aluminium hex claws act as a rigid interface between wheel and hub compared with many stock plastic hexes, reducing relative movement that can allow the wheel to slip under torque. They are useful when you need consistent wheel positioning for brake setup or when running high-torque motor/ESC combinations in RC-scale competition or practice.

This GPM ER0062MM/4 set offers a compact aluminum upgrade for E-REVO wheel mounting, providing a +2mm offset and integrated brake disk to help keep wheels seated and reduce slippage during model operation.