TRAXXAS E-REVO Carbon Steel Ring Bevel Gear 29T & Pinion 11T by GPM ER1200TS  [ER1200TS]

Carbon Steel ring & pinion for E-REVO

This 6pcs gear set is an aftermarket replacement intended for TRAXXAS E-REVO drivetrain use, built from carbon steel with a nitride case-hardened surface and precision helical spiral cutting for improved durability and smoother meshing compared with standard bevel-cut factory gears. The kit's primary role is power transfer within the inner front or rear gearbox, providing a direct replacement for worn or damaged bevel components while minimizing drivetrain noise and localised wear.

The set includes a 29T ring bevel gear and an 11T pinion gear, both 1.0 module, plus stainless steel flat head screws for secure mounting. The straight/helical bevel profile and case hardening help the gears resist pitting and maintain tooth profile under typical RC loads, making them suitable for hobby tuning and maintenance where reliable mesh and longevity are priorities.

Use this set when replacing inner gearbox bevel gears on supported TRAXXAS platforms, check mesh and backlash during installation, and reuse or replace bearings and mounting hardware as needed to preserve alignment and gear life.