TRAXXAS E-REVO POM Front and Rear Cupped Ball Threaded Collars by GPM ER021/DC  [ER021/DC]

POM cupped ball threaded collars for E-REVO

This RC-scale accessory is an 8pcs set of front and rear cupped seat ball threaded collars designed for TRAXXAS E-REVO use, manufactured in POM (polyoxymethylene). The material choice gives high stiffness and low friction for small precision parts used in wheel retention and suspension linkage points.

Installation is straightforward: the threaded collars sit on the ball stud seats and use the included rubber O-rings to help lock position and damp minor play. After mounting, adjust each collar to set the fixed tightness so that wheels are neither over-tightened (which can slow rotation) nor too loose (which can feel sloppy). This adjustment is useful when tuning wheel alignment and endplay on an RC-scale setup.

Use these collars where fine mechanical clearance and repeatable positioning are needed on the E-REVO, for example at wheel studs or linkage ball ends. They are a small tuning part intended only for RC vehicles and can help maintain consistent wheel behaviour during setup changes.