TRAXXAS E-Revo Steel#45 Front/Rear Steering Pillow Balls by GPM ER007S  [ER007S]

Steel #45 Steering Pillow Balls for TRAXXAS E-Revo

This aftermarket set provides 4pcs steel steering pillow balls intended for use on TRAXXAS E-Revo platforms and related models listed below. The parts are specified as Steel #45, and are designed as direct-fit replacement components for the front and rear steering assemblies on RTR-scale models.

Installation is straightforward for hobbyists familiar with steering linkages: remove the existing pillow balls from the steering knuckles and linkage ends, inspect the mating hardware for wear, then fit the steel pillow balls into the knuckles and tie-rods using the original screws or retained hardware. No chassis modification is required when used on compatible models.

In tuning terms, steel pillow balls increase durability at steering pivots and can slightly alter steering feel compared with softer materials; they are commonly used where hitters or heavy use accelerate wear on stock components. Check fit and free movement after installation and re-tighten fasteners to manufacturer torque recommendations for safe operation.

Use these pillow balls as a maintenance or upgrade item on the listed TRAXXAS models to restore steering geometry and improve pivot durability; verify part fit visually during the first run.