TRAXXAS E-REVO Upper & Lower Suspension Arms by GPM ER4567  [ER4567]

Aluminium front & rear suspension arms

This GPM ER4567 aluminium arm set is an aftermarket replacement designed for TRAXXAS E-REVO family models. The kit supplies both front and rear upper and lower suspension arms in a matched 8pcs set intended for RC-scale suspension geometry adjustments and long-term alignment stability.

The parts are machined from aluminium to provide a firmer mounting for ball ends and hinge pins compared with softer materials. In practice these components serve as a straightforward upgrade for drivers who want a more consistent pivot location during high-load manoeuvres and when fine-tuning camber, toe, or roll centre using standard setup methods.

Installation notes: the arms use existing hinge-pin locations and common fasteners on the listed TRAXXAS platforms; basic hand tools and a hex driver are all that’s required for swap-out. Careful pre-fit and turnbuckle re-check after first runs are recommended to confirm ride height and alignment remain within your setup targets.

For model builders seeking stable aluminium mounting points for front and rear suspension on TRAXXAS E-REVO variants, this 8pcs GPM ER4567 set integrates with standard hinge-pin layouts and includes the hardware needed for direct replacement and setup checks.