TRAXXAS FORD F-150 SVT RAPTOR OBA Front Driveshaft Assembly 6mm axle by GPM FR102F  [FR102F]

Front driveshaft for TRAXXAS 1/10 models

This is an RC-scale front driveshaft assembly designed for TRAXXAS 1/10 platforms, built from a combination of 6061 aluminum alloy and medium carbon steel with a constant-velocity (CVD) layout. The delivered parts replace the front drive shaft area and are supplied as a pair with matching screw pins for retention. The mixed-material approach aims to balance rotational strength with manageable weight for routine hobby use and drivetrain upgrades.

Installation replaces the front driveshaft components listed in the compatibility section below. Confirm axle diameter before fitting, the primary fitment here is for 6mm axle models; some listed entries use a 5mm axle and note an upgrade path where applicable. Secure the driveshafts using the supplied screw pins and verify spline engagement and clearance during initial test runs.

The assembly is intended to serve as a modular upgrade or replacement part to improve drivetrain consistency and durability in scale RC operation, particularly when upgrading or repairing the front driveline of compatible TRAXXAS models.

Use this assembly to restore or upgrade the front driveline on the supported TRAXXAS models listed above, confirming axle size and fitment before installation.