TRAXXAS Latrax Rally 1/18 hex adapter, wheel hub brake disk adapter by GPM LTX010D/+3MM  [LTX010D/+3MM]

Hex adapter for 1/18 Latrax Rally

This aluminium hex adapter is an RC-scale replacement part intended for use with the TRAXXAS 1/18 Latrax Rally platform, supplied as a 2pcs set. It serves as a hub-mounted adapter that positions the brake disk relative to the wheel and hub assembly, providing a +3mm offset that alters wheel stance and disk clearance when fitted.

In practical terms for model setup, the part is used when you need a modest increase in track width or when realigning a brake disk to avoid rub against the body or suspension components. Its aluminium construction focuses on maintaining positional accuracy and resisting wear from repeated wheel changes.

Installation is straightforward for standard Latrax Rally wheel setups: remove the existing hex, fit the adapter onto the hub, and reattach the wheel assembly so the brake disk and wheel align correctly with the vehicle geometry. Because this is an aftermarket hub adapter, check that existing wheel hexes seat cleanly and that mounting screws engage without cross-threading before use.

Tuning role: adding the +3mm adapter gives a small but useful change in track and leverage, which can affect handling feedback and clearance on tight setups. Use it when incremental adjustments to wheel offset are part of your setup routine rather than a major geometry change.