TRAXXAS LaTrax SST 1/18 Steel Servo Tie Rod with Plastic Ends by GPM LTX024A  [LTX024A]

This is a single aftermarket servo tie rod intended for 1/18 scale TRAXXAS LaTrax SST models, supplied by GPM as part LTX024A. It is an RC-scale steering link designed to replace or service the connection between the servo output horn and steering knuckle, using a steel rod body with plastic end fittings.

Compatibility is focused on LaTrax SST chassis variants that use the same steering linkage geometry, install as a direct replacement for the original tie rod, and retain factory mounting points. The part is provided as 1 pcs, intended for hobby use only and not for full-size vehicles.

Installation notes: fitment typically requires removal of the servo horn or steering arm to access the linkage, secure the plastic end fittings to the mating studs, and verify steering travel and centring before final tightening. For setup, check toe and steering response after installation and make small adjustments to achieve desired handling balance.