TRAXXAS MAXX 1/10 +20mm adjustable CVD drive shaft and 7075-T6 hex adapter by GPM TXMS143F/RSN  [TXMS143F/RSN]

Adjustable CVD drive shaft kit for MAXX

This GPM kit replaces the stock cross-pin drives with adjustable CVD swing joints to improve power transmission on 1/10 TRAXXAS MAXX platforms. The assembly pairs a hardened steel joint with a 6061-T6 alloy body to keep the combination stiff yet reasonably light. The design increases the axle diameter from 6mm to 8mm to handle higher loads typical of widened setups while maintaining an adjustable length for suspension tuning.

Parts provided include aluminum 7075-T6 hex adapters and wheel locks intended to work with the thicker axle, and appropriate 8x16x5 bearings are supplied to match the revised shaft dimensions. The kit is intended for front or rear drive shaft and wheel mounting and is noted as suitable for MAXX builds that use the +20mm widening kits.

For builders upgrading a TRAXXAS MAXX to a widened stance or seeking stronger, adjustable CVDs, this GPM kit provides thicker axles, hardened joints, and 7075-T6 aluminum hex hardware to support heavier loads and tuning adjustments on both front and rear locations.