TRAXXAS MAXX 1/10 Rear Stub Axle Carriers Aluminum 7075-T6 by GPM TXMS022N  [TXMS022N]

Rear stub axle carriers overview

This aluminum rear stub axle carrier set is an RC-scale replacement intended for TRAXXAS MAXX platforms, designed to keep the CVD drive shaft aligned and to support the wheel bearing under load. The components are machined from 7075-T6 aluminum to provide dimensional stability and predictable fitment at the chassis rear knuckle arm location.

Fitment covers the factory-style rear knuckle area, and the carriers act as a fixed point for the CVD and wheel bearing interface, helping reduce unwanted lateral play. Installation focuses on swapping the plastic stock parts for the aluminum carriers and checking bearing preload and CVD engagement during reassembly.

For hobbyists tuning rear-end stiffness or replacing worn plastic carriers, these aluminum rear stub axle carriers provide a direct-fit RC-scale upgrade that simplifies bearing checks and CVD alignment without changing drivetrain geometry.