TRAXXAS MAXX Front #45 Hardened Steel Ring & Pinion Gears by GPM TXMS1200FS  [TXMS1200FS]

TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS
Price:
USD$43.90
Brand:
GPM
Model:
TXMS1200FS
GTIN:
4894538334517
Condition:
Brand New
Write a review
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"
alt="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS" title="TRAXXAS MAXX MONSTER TRUCK Harden Steel #45 Front Differential Ring Gear & Pinion Gear - 2pc set - GPM TXMS1200FS"

Front ring & pinion gear set

This is an RC-scale front differential ring gear and pinion gear set produced for the TRAXXAS MAXX platform and finished in hardened steel #45. The parts replace the stock ring and pinion inside the differential case to reduce backlash and improve meshing under load.

The set is intended for hobby maintenance and tuning of MAXX drivetrains, where stiffer gear material and reduced gap can help maintain consistent power transfer from the motor through the differential. Installation requires access to the front differential case and standard RC tools.

Packing includes

  • Ring Gear - 1 pcs
  • Pinion Gear - 1 pcs

Original Name / Part No:

Improve the transmission of power in the differential case.

Specifications

  • Item Front differential ring & pinion gear set
  • Material Hardened steel #45
  • Model Number TXMS1200FS
  • Quantity 2 pcs
  • Compatibility TRAXXAS MAXX

Use this gear set when you need a direct replacement with increased durability and reduced gear play; verify fit and gear mesh during installation and recheck after initial test runs.

This item is compatible with

  • TRAXXAS-1/10 MAXX MONSTER TRUCK-89076-4
  • MAXX W/WIDEMAXX MONSTER TRUCK-89086-4

Will these gears fit the stock TRAXXAS MAXX front differential?

The product is produced for the TRAXXAS MAXX platform, check that your front differential uses the same ring and pinion dimensions before installation.

What tools are needed to install the gears?

Basic RC hand tools to open the differential case, a hex driver set for fasteners, and feeler methods to set proper gear mesh are typically sufficient.

How does hardened steel #45 affect performance?

Hardened steel #45 increases wear resistance compared with softer stock gears and helps the teeth maintain their profile under higher loads, which can preserve mesh consistency.

Any maintenance recommendations after installation?

After installation, run the vehicle at low speed to check noise and mesh, then re-torque fasteners and inspect for abnormal wear after several short runs.

Copyright © 2008-2026 rcjaz.com All rights reserved