TRAXXAS MAXX Monster Truck Aluminum 7075 25T Servo Horn 3pcs by GPM TXMS025T75  [TXMS025T75]

Aluminum 7075 25T Servo Horn for TRAXXAS MAXX

This aluminum servo horn is an aftermarket replacement part designed for use on TRAXXAS MAXX Monster Truck models, offered as a 3pcs set by GPM TXMS025T75. It is an RC-scale accessory made from 7075 aluminum to provide higher stiffness and wear resistance compared with stock plastic arms, and it is intended for the servo area to improve steering consistency.

Design notes: the straight-arm profile keeps link geometry predictable under load, helping to reduce play and maintain steering center. The 25T specification matches standard 25-tooth servo splines used on many MAXX setups, so the horn serves as a direct-fit option where a 25T mounting interface is required.

Installation and tuning role: install using the supplied stainless fasteners and confirm screw lengths and thread engagement for your servo horn and servo saver stack. After fitting, verify linkage alignment and trim endpoint and centering on your transmitter to take advantage of the increased rigidity without inducing binding. In tuning, this part aids in crisp steering inputs and improved feedback to the driver, particularly on rough surfaces where plastic arms may flex.

Included items in the package are listed below for reference, use these parts when replacing the servo horn to retain correct mounting hardware and position within the servo area.