TRAXXAS MAXX WIDEMAXX 110mm Extend CVD Shaft by GPM TXMW110F/RS  [TXMW110F/RS]

110mm Extend CVD Shaft for TRAXXAS MAXX

This is an RC-scale front/rear extend CVD shaft set designed for TRAXXAS MAXX platforms with WIDEMAXX geometry. The kit provides hard steel CVD shafts at 110mm length together with aluminum wheel locks and hex claws to replace or upgrade the drive connection between gearbox/diff and the wheels.

Components included support installation at the front or rear drive shaft area and are intended to transfer rotational power to the wheels while maintaining alignment under load. The set includes related outdrives, bearings, pins and set screws so the typical swap replaces the corresponding stock drive parts.

Use this set where a longer 110mm front or rear CVD is required on MAXX WIDEMAXX chassis, replacing the stock drive components with hardened steel shafts and the included hardware to restore drivetrain engagement and wheel retention.