TRAXXAS Revo / Revo 3.3 Alloy Front & Rear Completed Servo Mount by GPM TRV024  [TRV024]

Alloy front & rear servo mounts for Revo

This GPM TRV024 assembly provides front and rear alloy servo mounts supplied as completed units with mounting screws, intended for hobby-grade TRAXXAS Revo platforms. Designed for RC-scale use only, the set replaces standard plastic mounts to increase mounting rigidity and maintain servo alignment under load, helping keep steering responses consistent during tuning and track use.

Installation is straightforward for experienced model builders: the completed mounts accept common servo footprints and use supplied screws for direct replacement of stock parts. When fitting, verify servo horn clearance and pushrod geometry before final tightening, then test full steering travel to confirm there is no binding on the chassis or suspension at extremes.

As an aftermarket hop-up, these alloy mounts focus on improving the mechanical interface between the舵機 and chassis rather than changing servo performance; they are useful when upgrading servos or when a tighter mount is required for competitive or aggressive driving setups.