TRAXXAS Revo / Revo 3.3 Alloy Front Upper Arm by GPM TRV054RS  [TRV054RS]

Alloy front upper arm for TRAXXAS Revo (right)

This is an RC-scale replacement front upper arm tailored for TRAXXAS Revo and Revo 3.3 platforms, supplied as a single right-side piece. The part uses an alloy sandwich construction and ships with the mounting screws and pins indicated in the product name, so it arrives ready for direct swap on compatible suspension assemblies.

Functionally the arm serves as a direct replacement for the factory right-side front upper link, restoring suspension geometry and providing a more rigid mounting point compared with typical plastic arms. That rigidity helps the steering knuckle and shock mount points retain their alignment under load, which can simplify setup and trimming during tuning sessions.

Installation notes: this arm installs with the supplied pins and hex screws; verify the pin diameter and mounting hole alignment before final assembly, use a compatible hex driver to torque hardware evenly, and confirm clearance with the steering linkage and shock ends after fitting. As with any aftermarket part, test fit before track use and recheck fasteners after the first runs.