TRAXXAS Revo /Revo 3.3 / E-REVO Alloy Steering Holder by GPM TRV050  [TRV050]

Alloy steering holder for Revo series

This is an aluminium alloy steering holder intended for TRAXXAS Revo, Revo 3.3 and E-REVO model use in 1/10 scale RC setups. The part is supplied as 1 pcs set and includes the mounting screws needed to secure the holder to the chassis steering assembly. As an aftermarket replacement component from GPM (TRV050), it serves as a direct-fit steering support piece for the listed platforms.

Functionally the holder locates the steering components and provides a firmer mounting surface than common molded stock parts, helping reduce play in the steering linkages. Installation requires removing the original steering holder and fitting the alloy unit into the same mounting points, then fastening the supplied screws. After installation, verify free movement of the tie rods and correct servo horn alignment to avoid binding during steering travel.

Designed strictly as an RC-scale accessory, this holder is focused on structural support and repeatable steering geometry rather than a performance upgrade claim. Material is aluminium alloy and the package contains the holder plus the screws referenced in the product title.