Traxxas Revo Rear Rocker Arm 90T by 3Racing RE-012/S  [RE-012/S]

Rear rocker arm for Revo

This is an RC-scale rear rocker arm designed for Traxxas Revo applications, presented by 3Racing as part number RE-012/S. The part focuses on replacing a stock rear rocker to restore geometry and support suspension adjustments without altering other linkages.

The 90T designation indicates the rocker arm profile used in the Revo rear suspension layout, and the silver finish identifies the external appearance for visual matching. Use this component where the original rocker arm is worn, bent, or when setting up revised suspension rates.

Installation is straightforward for hobbyists familiar with Traxxas Revo service: remove the rear rockers, transfer any bearings or pins from the original part if required, and secure the replacement rocker to factory torque and threadlocker practices. Check hinge pin alignment and suspension droop after fitment to confirm correct geometry.

Use this rocker arm to maintain or restore rear suspension function on Revo chassis, keeping installation checks to standard Traxxas service procedures and verifying suspension balance after replacement.