TRAXXAS Revo Rear Rocker Arm 90T by 3Racing RE-012/T  [RE-012/T]

Rear rocker arm for Revo

This is an RC-scale rear rocker arm intended for Traxxas Revo chassis maintenance and setup. The unit is supplied as a single replacement pair and carries a titanium-color finish as noted in the product name, suitable for hobbyists who service or tune Revo suspension layouts.

The component's role is to transfer motion between the rocker and the shock assembly, affecting leverage ratios and rear suspension response. When swapping this part, confirm alignment with the stock mounting points and check clearance for adjacent suspension links and shock mounts before final tightening.

Installation notes: remove rear suspension linkage and shocks as required to access the rocker arm, preserve original hardware and bearings where present, and torque screws to the vehicle manufacturer's recommended settings. After installation, verify free movement through the suspension travel and perform a short test run to confirm intended handling changes.

Use this rocker arm as a direct replacement or service spare for Revo rear suspension work, focusing on fit verification and suspension setup to achieve consistent handling behaviour.