TRAXXAS Revo Steering Saver Mount by 3Racing RE-033/S  [RE-033/S]

Steering Saver Mount for Revo

This RC-scale steering saver mount is presented as a direct-fit accessory for the Traxxas Revo chassis, intended to locate and support a steering saver assembly while maintaining the vehicle's original mounting geometry.

The mount's purpose is to position the steering saver so that steering impacts and sudden loads are routed away from the servo and basic steering linkages, helping to stabilise steering feedback during aggressive driving or long runs. It is described as silver in appearance to match common Revo trim choices.

Installation is straightforward for experienced hobbyists: the part replaces the stock mounting piece using existing factory mounting points and hardware where applicable, allowing reuse of the original screws and link hardware. No specialized tools are required beyond standard RC workshop hex drivers and common hand tools.

In tuning terms, fitting an aftermarket saver mount like this lets you fine-tune steering compliance by combining different saver assemblies or link setups, so you can adjust how much impact is absorbed before the servo feels the load.