TRAXXAS Revo/Revo 3.3 Front Lower Arm (Alloy Sandwich, Right) by GPM TRV055RS  [TRV055RS]

Front lower arm for Revo 3.3

This is an RC-scale front lower arm produced by GPM for use on TRAXXAS Revo and Revo 3.3 platforms, supplied as a single right-side piece. The component uses an alloy sandwich layout with included screws and pins, intended as a direct replacement or spare for routine maintenance and tuning of the front suspension.

Use and installation notes:

• Confirm chassis side before fitment, the item is the right-side lower arm for Revo/Revo 3.3.
• Remove stock arm and compare mounting points and hole spacing prior to tightening hardware to final torque.
• Inspect included screws and pins during assembly and use thread locker on metal-fastened joints where appropriate for track use.

Tuning role and workshop guidance:

• As an alloy replacement, the arm provides consistent geometry for fine-tuning toe and camber settings in the front suspension during setup.
• Check for interference with steering links and servo output arm after installation, and verify full suspension travel under load.
• Keep this part as a service spare for quick track-side repairs or for iterative tuning when testing different shock and sway setups.