TRAXXAS Revo/Revo3.3 Hard Steel Ring Gear by GPM STRV1201  [STRV1201]

Hard steel ring gear for Revo

This GPM STRV1201 ring gear is an aftermarket RC-scale replacement designed for TRAXXAS Revo and Revo3.3 platforms, supplied as a single pcs unit. It is a direct-use drivetrain component intended to replace the stock ring gear with a hard steel option, keeping the installation and tuning context strictly within model-scale RC mechanics.

The part's role is focused on the gearbox section of the model: it provides a robust mating surface for the motor pinion and the existing spur arrangement, and is used when a builder wants a wear-resistant steel gear in place of softer materials. When fitted, expect the ring gear to serve purely as a transmission component in the RC model's drivetrain without any real-vehicle implications.

Installation notes: remove the gearbox cover and old ring gear, check that the ring gear seats flush and that the mesh with the motor pinion and spur gear is even, then reassemble and verify free rotation of the drivetrain before use. Pay attention to existing ball bearings and shaft alignment because correct clearance and bearing condition determine smooth operation and reduced noise.

Practical tuning role: swapping to a hard steel ring gear helps preserve tooth form under repeated use and can stabilise consistent mesh for subsequent pinion or spur ratio changes, making it useful for hobbyists who frequently adjust drivetrain ratios or run high-rev motors in model scenarios.