TRAXXAS Rustler 4X4 VXL Rear Stub Axle Carriers by GPM RUS4022N  [RUS4022N]

7075 Alloy Rear Stub Axle Carriers

This aluminium rear stub axle carrier set is designed as an aftermarket replacement for TRAXXAS 1/10 4x4 platforms. The components are machined from 7075 alloy to balance light weight with higher tensile strength, and the geometry focuses on stabilising the rear lower and upper arm junctions and the axle interface.

The kit positions 5x13x4 bearings in a tightened seat to minimise axial and radial play. Reduced gap at the bearing location helps the rear wheel joints rotate with more consistent alignment, which translates to steadier rear-wheel behaviour under acceleration, cornering and load changes.

Installation notes: the carriers are direct-replacement items for listed TRAXXAS models and reuse the original fasteners and bearings where applicable. Check bearing orientation and preload during reassembly, and verify clearance with the driveshaft and suspension linkages before final tightening.

Use these carriers to restore tight bearing alignment and reduce rear-end play on compatible TRAXXAS 1/10 4x4 models; they serve as a straightforward upgrade when replacing worn plastic housings.