TRAXXAS Rustler VXL Alloy Front Arm Bulk by GPM RUS008  [RUS008]

Alloy front arm bulk for Rustler VXL

This aftermarket alloy front arm bulk is designed for TRAXXAS 1/10 Rustler VXL scale models and serves as a direct replacement for the stock plastic units. As an RC-scale suspension component, the part provides a rigid pivot point for the front suspension, affecting steering geometry, toe stability, and camber behavior under load.

Installation is straightforward for hobbyists familiar with basic maintenance: remove the front suspension assembly, swap the bulkheads, check alignment of pin and bearing seats, and reassemble with recommended thread locker where applicable. No special tools beyond common hex drivers and a wrench set are required, but verify fitment on your chassis before full reassembly.

In terms of tuning, upgrading to an alloy front arm bulk can reduce flex at the pivot, offering a more predictable steering response when adjusting turn-in and mid-corner behavior. It is intended for RC tuning and repair tasks and should be used only on 1/10 scale Rustler VXL models as specified.

Use this GPM RUS008 alloy bulk to replace worn front bulkheads or to provide a firmer base for suspension setup adjustments on TRAXXAS Rustler VXL models.