TRAXXAS Slash 4x4 +25mm Alloy Hex Adaptor by GPM SLA010/+25MM  [SLA010/+25MM]

Hex adaptor for Slash 4x4

This alloy hex adaptor set is a 4pcs tuning accessory made for the TRAXXAS 1/10 Slash 4x4 platform. Each adaptor increases the wheel mounting offset by +25mm, allowing controlled changes to track width and wheel placement on scaled models. The parts are intended for hobby use only and serve as a mechanical tuning option when adjusting clearance, wheel fitment, or handling balance.

Installation notes: confirm the adaptor matches the Slash 4x4 wheel hex interface before fitting, fit one wheel at a time and verify clearance with the body and suspension travel, and retighten wheel fastening hardware after a short test run. Because these are alloy parts, check for proper seating and avoid over-torquing to protect wheel mounting surfaces.

Practical tuning role: use the +25mm offset to experiment with track width and cornering behaviour on the model, check for tyre rubbing and steering geometry changes after fitment, and combine with incremental suspension adjustments to dial handling to preference.