TRAXXAS SLASH 4X4 7075 Alloy Front Tie Rods With Stabilizer For C Hub by GPM SLA049LCGN  [SLA049LCGN]

Front tie rods for TRAXXAS SLASH 4X4

This is an RC-scale front steering tie rod assembly designed for the TRAXXAS Slash 4X4 platform, offering a direct replacement for the stock tie rods and C-hub mounting points. Machined from 7075 aluminium, the components focus on tensile strength and reduced weight relative to softer alloys, while preserving the geometry required for standard steering linkage setups.

The assembly includes an integrated stabilizer and a triangular reinforcement shape intended to increase lateral support at the steering knuckle without locking out necessary compliance in the suspension. The tie rod features an adjustable length and counter-clockwise thread on its end fittings to secure tie rod ends and allow fine steering toe adjustments during setup or tuning sessions.

Intended installation locations are the top of the C-hub, both sides of the front gearbox area, and the centre support mount region where the stabilizer interfaces with the chassis. This part is presented as a hop-up for improved steering consistency during technical off-road runs and setup iterations.

Use this 7075 alloy front tie rod and stabilizer assembly as a direct hop-up where you need firmer steering support and precise length adjustment on Slash 4X4 setups; follow standard RC fitting practices and verify thread direction during installation.