TRAXXAS Slash 4x4 Alloy Rear Arm Brace by GPM SLA009  [SLA009]

Alloy rear arm brace for Slash 4x4

This aftermarket rear arm brace is produced by GPM for the TRAXXAS Slash 4x4 platform and supplied as 1 pcs. It replaces the stock rear arm brace with an alloy unit intended to increase rigidity of the rear arm assembly on 1/10 scale Slash 4x4 models.

Installation is a straightforward swap that uses the existing mounting points on the rear suspension arms. Basic hand tools are sufficient, and the part interfaces with the same screws and locations used by the original plastic brace. Check thread engagement and torque settings on reassembly to avoid over-tightening aluminum parts.

For tuning, the alloy brace is intended to reduce flex in the rear arm area, which can sharpen rear-end feedback and maintain more consistent wheel alignment during jumps and hard landings. Expect a change in chassis feel rather than an increase in speed; adjust shock rates and toe settings after fitting to rebalance handling.