TRAXXAS Slash 4x4 Aluminium Turnbuckles with Plastic Ball Ends by GPM SLA160P  [SLA160P]

Aluminium completed turnbuckles for Slash 4x4

This is an RC-scale set of completed aluminium turnbuckles with plastic ball ends designed for use on Slash 4x4 and Telluride chassis. The kit contains 7pcs sized and finished for direct replacement of common factory linkages, providing a metal alternative to standard plastic rods while retaining plastic ball ends for noise reduction and simplified articulation.

Functionally these turnbuckles are intended to serve as adjustable link rods for steering and suspension geometry. Use them to set toe, adjust tie-rod length, or tune suspension link positions; length is adjusted by rotating the completed turnbuckle body, and the plastic ball ends clip or thread into stock-style ball studs. As an aftermarket aluminium component, they increase assembly rigidity compared with all-plastic links while keeping ball end compatibility with stock ball studs.

Installation is straightforward: remove the original link, match length roughly by hand, confirm thread engagement and ball end seating, then fine-adjust toe or link length with the turnbuckle. Check for free articulation through the suspension travel and verify no binding at full droop or compression. Regular inspection for thread condition and ball end wear will keep steering and suspension responses consistent.

For Slash 4x4 and Telluride owners who want aluminium adjustability with stock-style plastic ball ends, this 7pcs set offers a direct-replacement option for steering and suspension link tuning without chassis modification.