TRAXXAS Slash 4x4 Hard Steel Bevel Gear by GPM STRV1202/G1  [STRV1202/G1]

Hard steel bevel gear for Slash 4x4

This aftermarket bevel gear is a single-piece hard steel replacement designed for the TRAXXAS Slash 4x4 platform, produced by GPM under the model STRV1202/G1. It is intended as a direct service part to replace worn or damaged bevel gears in compatible 1/10 scale RC drivetrains.

Fit and compatibility are limited to models that share the same internal bevel gear geometry. The original listing identifies suitability for Revo and Slash 4x4, so confirm your chassis matches those platforms before ordering. The part is supplied as 1pcs.

Installation notes: access to the vehicle gearbox is required and some disassembly is typically necessary to remove the old bevel gear and install the replacement. Inspect adjacent components such as bearings and spur/pinion engagement during reassembly, and set gear mesh to the manufacturer’s recommended clearance to avoid premature wear.

Tuning role: upgrading to a harder steel bevel gear reduces deformation risk under higher torque or worn conditions compared with softer materials, helping maintain consistent gear mesh and drivetrain behavior during spirited running or when using higher-power motors and ESC setups.