TRAXXAS SLASH 4X4 Low-CG Front Tie Rods with Stabilizer by GPM SLA049LCG  [SLA049LCG]

Low-CG front tie rods with stabilizer

This GPM SLA049LCG RC-scale upgrade replaces the top link area on the C-hub and the support points near the front gearbox and center support mount on TRAXXAS SLASH 4X4 models. The kit is intended to let builders fine-tune steering geometry by changing tie rod length and adding a small stabilizer at the top mount.

The assembly is adjustable: insert a thin tool into the positioning hole on the tie rod to rotate the threaded section and change effective length. The parts are machined from aluminum 6061 T6 to provide a balance of reduced weight and higher tensile strength compared with standard plastic components. The tie rod uses a counter-clockwise thread for its adjustable section and features a triangular holder design aimed at increasing lateral stiffness while retaining necessary flex for suspension movement.

The set ships as an eleven-piece kit that covers both sides of the front assembly and includes mounting hardware sized for straightforward replacement of the stock top link hardware. Use common hand tools such as a hex driver to fit the screws, and verify steering geometry on a workstand before track runs.

For TRAXXAS SLASH 4X4 users seeking a lightweight, adjustable top-link upgrade, this GPM kit offers direct-fit aluminum parts for steering length tuning and a modest increase in front-end stability without drastic geometry changes.