TRAXXAS Slash 4x4 screw pins for F/R CVD drive shaft by GPM SSLA1277RHP  [SSLA1277RHP]

F/R CVD screw pins for Slash 4x4

This GPM aftermarket set is a simple RC-scale accessory intended to stabilise the front and rear CVD drive shaft joints on TRAXXAS Slash 4x4 models. It is supplied as a 2 pcs replacement set to match the original screw-pin function used in the Slash F/R CVD yoke.

The pins serve to maintain axial and rotational position within the CVD assembly, helping to reduce end play and maintain consistent driveshaft engagement under load. Use them where the original pins are worn, bent, or have excessive play that affects driveline behaviour.

Installation is straightforward for experienced model technicians: remove the CVD assembly, swap the worn pin for the replacement, and reassemble following the vehicle's original fastening method. The part is an RC-scale replacement designed to fit the Slash F/R CVD interfaces specified in the original product title.

Tuning role: these pins are a minor but practical hop-up for driveline reliability; they do not alter gear ratios or motor performance but help preserve consistent power transfer by keeping the CVD components correctly located during aggressive use.