TRAXXAS Slash 4x4 Spring Steel Completed Turnbuckles with Plastic Ball Ends by GPM SSLA160P  [SSLA160P]

Completed spring steel turnbuckles for Slash 4x4

This is a 7pcs completed turnbuckle set designed for RC-scale use on TRAXXAS Slash 4x4 platforms and Telluride models. Each assembly is supplied with spring steel rod sections and plastic ball end fittings, supplied ready to thread into existing linkage points.

The assemblies serve as direct replacements for OEM turnbuckles where the same ball end interface and general length envelope are used, offering a corrosion-resistant spring steel shaft and low-friction plastic ball ends. They are intended for steering and rear toe adjustments and for hobbyists tuning suspension geometry on track or off-road layouts.

The product arrives as a ready-to-install kit of 7pcs that simplifies setup by eliminating separate rod and ball end assembly steps; users replace worn or bent linkages without fabricating parts.

Use these completed turnbuckles to restore steering accuracy and maintain consistent toe settings, noting they are intended for RC-scale Slash 4x4 and Telluride assemblies only.