Traxxas Slash 4x4 Widen Rear CVD Drive Shaft & Knuckle Arm by GPM SSLA1277FH22  [SSLA1277FH22]

Widen rear CVD drive shaft kit

This is an RC-scale rear drive upgrade designed for the Traxxas Slash 4x4 family. The assembly combines hardened steel and 6061 T6 aluminium where noted to balance strength and weight in offroad use. The axle section is increased in diameter to handle higher impact loads from jumps and aggressive bashing, while the knuckle arm uses aluminium to resist deformation.

The kit includes precision bearings for smooth rotation and a spring steel hex to keep the hub connection tight under load. These details make the component suitable as a targeted upgrade for drivers who need a tougher rear end without a wholesale driveline redesign.

Installation notes: the parts are direct-fit for the listed Slash variants and replace the stock rear CVD and knuckle assembly. Check existing hardware for wear and verify fit on the rear hub before regular use. The part is intended for RC-scale vehicles only.

Use this rear CVD and knuckle arm set when you want a sturdier rear driveline for frequent jumps and hard offroad runs on Slash 4x4 platforms.