TRAXXAS Telluride 4x4 Aluminium Main Shaft with Hardened Steel Ends by GPM TEL025  [TEL025]

Aluminium main shaft for drivetrain

This aluminium main shaft with hardened steel end fittings is an aftermarket replacement part for TRAXXAS Telluride 4x4 RC models. As an RC-scale drivetrain component, it combines an aluminium shaft body with hardened steel terminations to concentrate wear resistance where the shaft couples to gears and bearings. The part is intended for routine replacement, targeted tuning, or when upgrading drivetrain durability on model off-road setups.

The shaft is supplied as a single pcs unit and is intended to fit the Telluride 4x4 platform as indicated by the product title. Installation typically involves removing the gearbox or axle housing cover to access the original main shaft, swapping the shafts, and verifying gear mesh and bearing alignment. Small adjustments to spur and pinion spacing or bearing preload may be required to maintain smooth operation after replacement.

When installing, check for proper seating of the steel ends into bearings and confirm there is no excessive axial play. After installation, perform a short test run at low load to ensure the drivetrain runs smoothly before full use. Routine inspection of the hardened ends and surrounding bearings will help detect wear early and prevent secondary damage to gears.

Use this shaft when replacing worn drivetrain components or when seeking a straightforward durability upgrade for TRAXXAS Telluride 4x4 models; verify fit and gear mesh during installation.