TRAXXAS Telluride 4x4 Front CVD Drive Shaft with 12mmx6mm Wheel Hex by GPM TEL1273FH  [TEL1273FH]

Front CVD drive shaft for Telluride

This aftermarket front CVD drive shaft is a scale RC replacement part designed for TRAXXAS Telluride platforms, supplied as a 1pr set by GPM TEL1273FH. The assembly pairs steel and aluminium components to balance strength and weight, and it keeps the RC-specific function in focus without implying any real vehicle application.

Design notes: the unit uses a revised CVD head and a reinforced 12mmx6mm wheel hex interface to reduce play and secure the wheel mounting. The shaft is described as lighter than earlier designs while offering improved durability where the CVD head meets the hex, which helps maintain drive geometry during normal trail and bash use.

Fit and setup: length is adjustable to accommodate different chassis offsets and ride heights, so verify total length and C-hub alignment before final assembly. During installation, confirm that the wheel hex seats fully and that the drive cups rotate freely through the suspension cycle to avoid binding with the axle or steering linkages.

For modelers seeking a direct-replacement front shaft that balances reduced weight with reinforced connection points, this GPM unit provides an adjustable option for fitting TRAXXAS Telluride-based rigs while keeping installation straightforward.