TRAXXAS T-Maxx 1/10 Alloy Completed Tie Rod Set by GPM TMX10160  [TMX10160]

Alloy completed tie rod overview

This GPM TMX10160 aftermarket tie rod set is an RC-scale steering linkage option produced for the TRAXXAS 1/10 T-Maxx platform, supplied as a completed assembly with fasteners and collars in a 2prs set. The component is made from alloy and intended as a direct replacement or upgrade for the vehicle's steering tie rods, addressing play or wear in the steering linkage without implying any full-scale vehicle use.

The set includes finished tie rod assemblies designed to connect steering components, with the supplied screws and collars intended to secure rod ends and help retain geometry under load. This product serves a tuning role by allowing hobbyists to replace worn parts, maintain alignment, and fine-tune steering response on the RC monster truck chassis.

Installation overview: remove the stock tie rod assemblies from the steering knuckles and servo horn area, transfer any required rod ends or ball joints if applicable, fit the provided tie rods using the supplied screws and collars, then verify neutral steering and toe settings before test runs. Use appropriate tools and check compatibility with your servo, linkage ends, and ball bearings prior to fitting.

For TRAXXAS T-Maxx owners seeking a straightforward alloy tie rod replacement or steering-linkage option, the GPM TMX10160 provides completed assemblies with hardware to restore steering feel and support setup adjustments on the RC monster truck.