TRAXXAS T-Maxx 1/10 Alloy Servo Mount with 4mm Steel Handle by GPM STMX2112  [STMX2112]

This GPM aftermarket servo mount and handle set is an RC-scale upgrade designed for TRAXXAS 1/10 T-Maxx platforms, supplied as a single set for direct replacement of the stock mounting hardware. The kit combines an alloy servo mount with a 4mm steel handle intended to increase local stiffness where the servo interfaces with the chassis during high-load off-road runs.

Installed in place of the original plastic mount, the alloy component serves to reduce flex at the servo mounting points, which can improve steering consistency when using stronger servos or when tuning for aggressive suspension and jump setups. The 4mm steel handle provides a more rigid link between servo output and the steering linkage, useful when dialing in precise steering feel on rough terrain.

Installation notes: the part is supplied as an RC accessory intended for TRAXXAS T-Maxx 1/10 models; expect to reuse existing mounting screws and verify hole alignment and servo spline engagement. Minor trimming or shimming of surrounding mounts may be required to achieve flush fit on older or heavily modified chassis. Check thread engagement and use thread locker where appropriate for durable assembly.

Tuning role: use this alloy mount to reduce unwanted movement at the servo anchor, then revisit steering endpoints and subtrim after installation to account for the change in mechanical leverage. This component is intended to complement suspension and steering setup rather than replace tuning of ESC, motor, or shock settings.