TRAXXAS Tmaxx 3.3/Tmaxx 1.1 Alloy Front Gear Box Brace by GPM TMX1012A  [TMX1012A]

Alloy Front Gearbox Brace

This alloy front gear box brace is an RC-scale accessory designed for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 platforms. It replaces the stock front gearbox cover area with a single-piece aluminum brace intended to add rigidity to the front section of the drivetrain while remaining compatible with the vehicle’s original mounting points.

Compatibility is indicated in the product name, and the part is supplied as a 1 pcs set including the necessary screws for installation. Installation typically uses the existing bolt locations on the front gearbox and does not require modification of the chassis; users should verify alignment before final tightening.

On setup and tuning, the brace functions as a structural reinforcement: increasing front gearbox stiffness can help maintain gear mesh under higher torque from aggressive motor and ESC combinations, and can alter how load transfers into the suspension during acceleration or impacts. Expect subtle changes in handling that should be assessed during test runs and incremental setup changes.