TRAXXAS TRX-4 Aluminum Front C-Hubs by JAZRIDER JR-TRX411-BK  [JR-TRX411-BK]

Aluminum front C-hubs for TRX-4

This is an aluminum front C-hub set made for the Traxxas TRX-4 scale and trail chassis, supplied under the JAZRIDER JR-TRX411-BK designation. It is an RC-scale steering component intended to replace the stock front C-hubs and provide a more rigid mounting point for the steering knuckle.

Installers should treat this as a direct-fit part for TRX-4 mounting points, verifying alignment with existing knuckles and linkage. Because the component is metal, check torque on hex screws and confirm clearance for steering links before first run. Use recommended RC practice when tightening to avoid thread damage to the chassis or knuckle hardware.

In tuning terms, swapping from plastic to aluminum C-hubs reduces flex at the hub interface, which can make steering feel more consistent under load and maintain geometry during technical maneuvers. That change can affect toe and steering feedback, so validate wheel alignment and steering endplay after installation and adjust toe or steering trims as needed on the transmitter or linkage.