TRAXXAS TRX4 Front and Rear Aluminum Gearbox 2-speed Differential Lock Servo Mount 11pcs by GPM TRX4034FR  [TRX4034FR]

Aluminum servo mount for TRX4

This RC-scale accessory provides a compact mounting solution for the front and rear gearbox areas on TRAXXAS TRX4 trail crawler builds. It is intended to stabilise the舵機 and the 2-speed differential lock linkage, reducing movement under load and helping maintain consistent engagement during slow-speed crawling and pulling maneuvers.

The component is CNC-machined from aluminum 6061 T6 with a hollowed, streamlined profile to lower mass while keeping tensile strength where the diff-lock forces mount. Two aluminum posts are supplied to sit beneath counter-sunk positioning holes for additional support. Fasteners included are stainless steel to resist corrosion in outdoor trail use.

Installation notes: fit the mount to the gearbox mounting points and secure with the supplied screws, position the aluminum posts under the countersinks for support, and check servo alignment before final tightening. Minor trim or adjustment of linkages may be required to match your existing servo horn and differential lock actuator geometry. This part is supplied as an 11pcs set to cover both front and rear mounting locations on a TRX4 platform.