These front C-hubs are an RC-scale replacement part intended for Traxxas TRX-4 setups. The component serves as the steering knuckle mount point and affects front axle geometry, load path, and serviceability on scale trail and rock-crawling rigs.
Compatibility is stated for the TRX-4 chassis; verify alignment with your existing axle housings and spindle orientation before installation. The listed color is black, and the design is described as heavy duty in the product name.
Installation typically replaces the stock C-hubs using existing mounting points and hardware, though inspect screw lengths and thread fit to avoid interference. When fitting, check steering linkage clearance and ensure the servo horn and tie-rod angles maintain intended steering travel to prevent binding.
In tuning terms these C-hubs are a chassis-level part that can influence caster, toe under load, and steering feedback; changes should be evaluated on the bench and during low-speed trials before full trail use.
Use these C-hubs when you need a direct replacement with a heavier-duty intent for TRX-4 scale trail use, and plan setup checks for steering geometry after fitment.
Copyright © 2008-2026 rcjaz.com All rights reserved
