TRAXXAS TRX4 MERCEDES-BENZ spare tire support mount by GPM TRX4ZSP67  [TRX4ZSP67]

Spare tire support for TRX4 Mercedes

This stainless steel spare tire support is an RC-scale accessory designed for the spare tire area of TRAXXAS TRX4 MERCEDES-BENZ 1/10 crawlers, intended to secure and position a range of spare tire sizes without implying any full-scale use.

Adjustment is done via the screw on the hook, allowing about a 1cm height range to accept different tire diameters. The main plate is 1.2mm stainless steel to reduce corrosion risk and provide rigidity. The assembly uses two stainless plates with fixed screws and locknuts on each side, plus gold-coloured screws and shims included for setup; installation may require drilling or reaming at the mounting points.

Typical installation notes: locate the mount in the spare tire area, test-fit the spare, adjust the hook screw to the required height, and secure the locknuts. Use the supplied 2.5mm drill bit if holes need enlarging, and verify clearance before final tightening to avoid interference with bodywork or suspension travel.

• Support Mount - 1pcs
• 3M Double-sided Tape - 1pcs
• 2.5mm Drill Bit - 1pcs