TRAXXAS TRX4 Plastic Ball Ends 12pcs by GPM TRX4160A/BE  [TRX4160A/BE]

Replacement plastic ball ends for TRX4

This set supplies 12 plastic ball ends intended as replacement parts for the GPM Racing TRX4160A assembly used on select TRAXXAS TRX4 models. They are produced as RC-scale components and are specified by the supplier as replacements for GPM Racing #TRX4160A only, not for original manufacturer parts.

Use these ball ends where the TRX4160A assembly locates ball joint connections; they restore articulation at linkage points and allow adjustment of steering and suspension geometry without replacing the entire linkage. The supplied quantity covers multiple linkage positions or a full axle service on a crawler setup.

Installation notes: remove the worn ball ends from the TRX4160A sockets, press or seat the replacement ball ends into the same positions, and verify free articulation and a secure fit. Inspect for play after first runs and replace any unit that shows excessive wear.