TRAXXAS TRX4 TRAIL CRAWLER 23mm Aluminum Hex Adapters by GPM TRX4010/23MM  [TRX4010/23MM]

Hex adapter upgrade for TRX4

This is a 23mm aluminum hex adapter set designed for TRAXXAS TRX4 Trail Crawler use on RC-scale models, supplied by GPM (TRX4010/23MM). The adapters move the wheel mounting point outward to widen track width and close the gap between wheel and chassis so the wheel sits closer to the body.

Functionally these adapters sit between the wheel hex and the hub or driveshaft end, allowing the front CVD and rear driveshaft to connect with the wheel while increasing lateral track. The extra 23mm thickness (noted as 18mm thicker than the original reference hex) changes wheel offset and helps stabilize the chassis during slow-speed crawling and on uneven terrain.

Installation is plug-and-play: remove the wheel hex, fit the adapter onto the hub or CVD end, then refit the wheel and secure hardware. They are produced in aluminum for stiffness and weight control, and come in multiple colors to match chassis styling or to aid quick identification during setup. This is an RC-scale accessory intended to adjust handling and clearance, not for full-size vehicle use.

Included hardware from the product source: Stainless steel screw shaft M4*2.5*11.8 - 4 pcs, 5mm shims - 4 pcs, 5mm metal washers - 4 pcs, stainless steel hex socket screw 19mm - 4 pcs.